MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Blacet Phaser LFO issue
MUFF WIGGLER Forum Index -> Fractional Rack Modules  
Author Blacet Phaser LFO issue
recompas
I'm having a strange issue with my Stonez phaser. On startup the LFO runs, but after a short time it sort of stops and none of the controls get it going again. Not sure where to start. I tried a little while ago to debug it, and replaced the LFO op amp thinking that might be an issue. Now I'm wondering about the CV mixer section.

Any thoughts?
fracmonkey
Sounds like a cold solder joint. These have a characteristic donut shape when viewed under magnification. If the LFO starts back up when you wiggle the PCB, then this might be the culprit...
MUFF WIGGLER Forum Index -> Fractional Rack Modules  
Page 1 of 1
Powered by phpBB © phpBB Group