I have a Storm and Moons (DIY) connected via expander cable. The modules had been working OK until I did some rack re-arrangement yesterday.
The issue is that I am getting very very weak output from VCA 2 when using expander connection i.e. when no jack is plugged into VCA 2 IN. When I plug the signal into VCA2 all is working fine. VCA 1 and XOR OUT are all good.
Any advice what to look at is appreciated.
Thanks!
ilya.n
Well, it started working after i took the panel off and pushed all ICs firmer in their sockets... Don't know what was it...
FAQ & Terms Of Use
MW Radio
Twitter
Patreon
Search
Sign up
Log in