MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Set SAM to show
Discontinuity D17/18 1N5819 or 1N4001
MUFF WIGGLER Forum Index -> Oakley Sound Systems  
Author Discontinuity D17/18 1N5819 or 1N4001
mmeixner
Just a short question while building the Discontinuity (PCB v. 3.1):

D17 and D18 are specified as 1N5819, in the schematic they are 1N4001 - may I use either of these? I guess, the Schottky diode would give better reverse voltage protection - is this right?
Synthbuilder
The parts list in the Builder's Guide is always the one to use. I keep the parts lists updated but not so much the schematics.

In this case, either diode will do. The diodes are there to catch any misbehaving from the power supply on power up and down.

Tony
MUFF WIGGLER Forum Index -> Oakley Sound Systems  
Page 1 of 1
Powered by phpBB © phpBB Group