br>Blake Smith |
br>Hi there,
I'm putting together an RPSU with the intention of powering an HVM and SE330, and will be using a single phase 16v 1000ma AC adapter.
I wasn't reading the build document close enough and I went ahead and soldered in D9 and D9, however they are indicated as not needed in the case of a single phase supply. Will it hurt anything if they are left in place, or should they be taken out?
Also, just so I understand the ripple requirement on the 1000u electrolytic caps, the 750ma ripple requirement is a minimum rating, so if the cap has a higher ripple then it should be more than adequate?
Thanks,
Blake. br> br> |
|