MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Frac panel tolerances?
MUFF WIGGLER Forum Index -> Fractional Rack Modules  
Author Frac panel tolerances?
flight
I got some 1w and 2w panels cut, but they are all oversized by 0.025"-0.05" (onlinemetals.com states their cut tolerance to be 0.125", so I got lucky). How tight are the tolerances on standard Frac panels?
Cybananna
+/- .010 and +/- .005 for holes.


http://www.blacet.com/tech.html

There's a drawing at the bottom of the page.

This is for Blacet at least. not sure about others.
flight
I figured as much, oh well. I can file 'em down. I'll get a micro-mill one of these days (as soon as I get a workshop to put it in).
MUFF WIGGLER Forum Index -> Fractional Rack Modules  
Page 1 of 1
Powered by phpBB © phpBB Group