MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

ADDAC0017 Modular to Oscilloscope Cable Pair
MUFF WIGGLER Forum Index -> ADDAC System  
Author ADDAC0017 Modular to Oscilloscope Cable Pair
Midiot
ADDAC0017
Modular to Oscilloscope Cable Pair.

LINK
Description:
"This Bnc to 3.5mm female jack cables allow easier integration with most oscilloscopes.
An extremelly simple way to go from your modular to your oscilloscope."


Any info on this ?

From the photo, it looks like it's using the Tek P6100 connectors, which are :
DC to 100 MHz
10:1 and 1:1 Switchable

What is the cable capacitance (and length) ? (likely not an issue, but I'm curious)
Are they currently available ?
JohnLRice
Those look nice and are reasonably priced, I should buy a pair (or make some like that).

I've often used regular probes clipped to a spare jack and I've also just used straight 1/4" or 3.5mm to BNC adapters.
Midiot
JohnLRice wrote:
.............3.5mm to BNC adapters.


That's also what I have been using... sort-of. but not dedicated scope probes.
BNC to BNC male cables (thin flexible RG174 cable, 50ohm) and the appropriate 3.5mm adapter(s).

My scope is a Tektronics 2246 (100Mhz).
ADDAC System
The ADDAC0017 are readily available through our website!
MUFF WIGGLER Forum Index -> ADDAC System  
Page 1 of 1
Powered by phpBB © phpBB Group