MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

best acrylic/material for laser cut panels
MUFF WIGGLER Forum Index -> Music Tech DIY  
Author best acrylic/material for laser cut panels
pix
Any suggestions for hard and resistant materials that can be cut and engraved with a laser cutter? I've been using acrylic but I think it's not hard enough once you get to ~2mm depths.
julian
What about asking whoever runs the laser as to what it can cut?

I would think that they would know better than any of us the toughest material that it can handle.
MUFF WIGGLER Forum Index -> Music Tech DIY  
Page 1 of 1
Powered by phpBB © phpBB Group