MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

CP3 in MOTM?
MUFF WIGGLER Forum Index -> 5U Format Modules  
Author CP3 in MOTM?
synthetic
Did anyone ever make a clone of the Moog CP3 mixer in MOTM format? There are a bunch in MU format, is there a panel or something to make it work in MOTM rack/power? I gather that STG made some of his modules in MOTM format but only for only a few minutes. Thanks.
Synthbuilder
I do one. But mine comes with a 904A clone low pass filter bolted onto the output of the mixer.

http://www.oakleysound.com/dlf.htm

Tony
krisp14u
if you can DIY this is worth a look
https://midisizer.com/5u/cp3-mixer/
unrecordings
krisp14u wrote:
if you can DIY this is worth a look
https://midisizer.com/5u/cp3-mixer/


+1 on this version. Peter was really helpful with calibration

I built two in MOTM format
LED-man
I built for a friend many years ago a 16 channel CP3 mixer, only 2u width.
https://www.dsl-man.de/display/MAIN/CP3+Mixer+-+Quad+CP3+Mixer+in+MOTM

Last week I finished a MU Module with the Eurorack CP3 pcb from feedback.
It was a fast and cheap build
diophantine
krisp14u wrote:
if you can DIY this is worth a look
https://midisizer.com/5u/cp3-mixer/

+1 on Peter's stuff. I knew someone was doing a DIY MOTM CP3, but I forgot it was him, despite being on his site a million times in December while building a bunch of his MidiSizer stuff. Super nice & helpful guy.
synthetic
This is me finally looking at responses a month later. Thanks all!

Then again I just found a 6U wide Dotcom cabinet that someone gave me. Maybe I'll look for a MU format that's not too deep and start a new system. smile
MUFF WIGGLER Forum Index -> 5U Format Modules  
Page 1 of 1
Powered by phpBB © phpBB Group