Muff's Modules & More

lorenzovektor · Posted: Sat Nov 12, 2011 9:22 pm Post subject: Envelator Basics

I think I downloaded these files from Wiard's site a while ago,

Some Envelator basics

infradead · Posted: Sat Nov 12, 2011 11:24 pm Post subject:

handy!

thanks

worker8 · Posted: Sun Nov 13, 2011 5:31 pm Post subject:

Just tried to plug audio in the gate input. That works well. Almost an envelope follower.

lorenzovektor · Posted: Mon Nov 14, 2011 6:09 pm Post subject:

can we sticky this?

jimmyedgar · Posted: Wed Nov 23, 2011 6:37 am Post subject:

Kodama · Posted: Wed Nov 23, 2011 10:53 am Post subject:

End is cool, it is high as long as the envelope is not active (as opposed to an end of cycle trigger).

infradead · Posted: Wed Nov 23, 2011 12:37 pm Post subject:

PhineasFreak · Posted: Wed Nov 23, 2011 12:53 pm Post subject:

the knobs are odd and the cv's for A/D too i think. without being next to it to check, am sure the knobs go cw for longer unlike my other EGs such as RS60s, and the cv can be input as -ve and +ve to lengthen and shorten unlike some other EGs i've tried...

fac · Posted: Wed Nov 23, 2011 2:13 pm Post subject:

That's right. The knobs determine the rate of change, not the attack/delay time. It makes more sense when you use the Envelator as an LFO.

BTW.- there are other synths where the length of the envelope stages is determined by a rate control, rather than a time control. The DX7 is one example.

hank · Posted: Sat May 05, 2012 1:20 pm Post subject:

Thank you for this! I thought I had tried all variations of modes/settings when trying to figure out delay, but clearly missed cycle. d'oh!