Cwejman, Livewire, TipTop Audio, Doepfer etc... Get your euro on!
Moderators: Joe., lisa, luketeaford, Kent
- Wiggling with Experience
- Posts: 293
- Joined: Tue Oct 02, 2018 9:25 pm
- Location: Boston
dumbledog wrote: ↑
Fri Mar 27, 2020 4:06 pm
versipellis wrote: ↑
Thu Mar 26, 2020 4:31 am
This is clever! What's the s&h used for?
The S&H is there to send the pitch to the oscillator only if the gate from Compare 2 is high. If it isn't high then the pitch remains the same -- the oscillator essentially ignores the pitch from Bloom.
Again, very creative - thanks. If I could give you a cookie for that, I would!
- Learning to Wiggle
- Posts: 2
- Joined: Sat Feb 16, 2019 1:56 pm
I'm having a weird issue with my Bloom: when I press the channel button, both outputs change octaves. So when I'm on channel one and change to channel two, both sequences jump an octave. Resetting or updating the firmware didn't help. Anyone else seen this?