From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!
thanks the bad producer! it's been awhile since i checked in here...i did try with polarity corrected after replacing the ic's and nada. i used the 10r resistors at the power input. i will replace the caps and the two resistors and try it with the new ic's, hopefully that does it. all my hard work foiled by the stupid power ribbon thing.
Is there a spare kit, PCB set and panel anywhere that could be sold on to a wiggler like me keen to explore the sonic potential such a circuit invites?
The panels are the hard part... usually group buys justify/offset cost
I have a completed MKI (not MKII) panel available (in europe), PM if interested.
Thanks robotfunk for the offer.
Besides the panel and tactile nature of the MKI, I am interested in the additional output options from each band available with the MKII.
Apologies for cross-posting, but there was some discussion over in the RS ResEQ Thread about how to tap the individual outs, and now I see that this version’s mk2 actually does have individual outs. Are they additionally buffered or just tapped straight where they would be on the RS, and are they pre or post attenuator?
Any pcb left somewhere ?