I ordered a couple of the easier module PCB's and faceplates for the System 700 and am gathering parts for these projects while I wait for these parts to arrive. I hope to prove myself with these simple modules and then if successful purchase more modules to build a reasonable clone of the the venerable System 700 if PCB's are still available at that time.
Thanks very much for providing Mouser project links, that is very helpful in sourcing the parts to newcomers such as myself.
I am not sure what pots to order and am wondering how to best confirm whether a given pot will work with the PCB layout and circuit, and would like to know how to best get an answer without being annoying or redundant. I have built stomp boxes before, but have not mounted pots onto PCB's to date (the stomp boxs' knobs and switches were wired up rather than mounted on the board). I currently plan to build the 709 S&H and 716 Mixer modules.
I am considering these pots for the 9mm 100k linear pots used in the Mixer:
https://www.mouser.com/ProductDetail/317-2090F-100K
I am considering this pot for the 16mm 1M reverse log pot used in the S&H:
https://www.mouser.com/ProductDetail/BI ... gasyk7zO83
Do these seem like reasonable pots for the job? Thank you for your time.