using 4ms row power for breadboarding circuits

From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!

Moderators: lisa, luketeaford, Kent, Joe.

Post Reply
ketem13
Common Wiggler
Posts: 229
Joined: Tue Jan 16, 2018 2:02 pm

using 4ms row power for breadboarding circuits

Post by ketem13 » Sat Feb 08, 2020 4:15 am

Hi,

I'm looking for a solution in order to breadboarding some diy circuits that require +12 -12 and gnd on a breadboard .
I look for other solution rather then two 9v battery in order to make +-9 v and gnd - I did this method and the wires that connected to the breadboard
and been powered from the two batteries got really hot .

Is the 4ms row power is good for that? (mainly is the question of safety)

Thanks

Post Reply

Return to “Music Tech DIY”