DIY Peaks Calibration Method? (Not Present Online)

From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!

Moderators: Joe., lisa, luketeaford, Kent

Post Reply
User avatar
gamblid
Learning to Wiggle
Posts: 36
Joined: Wed Jun 20, 2018 11:45 pm

DIY Peaks Calibration Method? (Not Present Online)

Post by gamblid » Tue Mar 24, 2020 6:44 pm

I have a diy peaks from blue lantern i just finished but can't seem to find anywhere online how to calibrate it. This is the only vague thing i found online:

To enter calibration mode, power the module on with the second button pressed. The first and second knobs (third and fourth) act as coarse/fine adjustments for offset on channel 1 (channel 2).

Ok... there is the following buttons: Split, Mode, Trig 1 and Trig 2. Is it talking about trig 2?

but what am I supposed to do after that? what do i press to save calibration?

It seems the calibration method was either removed or never added to the official Mutable Instruments website

User avatar
Agawell
Ultra Wiggler
Posts: 779
Joined: Mon May 04, 2015 3:22 am

Re: DIY Peaks Calibration Method? (Not Present Online)

Post by Agawell » Wed Mar 25, 2020 5:14 am

gamblid wrote:
Tue Mar 24, 2020 6:44 pm
The first and second knobs (third and fourth) act as coarse/fine adjustments for offset on channel 1 (channel 2).
The answer to the question is in the question

adjust the pots so you get 0 offset on the outputs

User avatar
forestcaver
Veteran Wiggler
Posts: 584
Joined: Tue Mar 14, 2017 4:41 pm
Location: UK
Contact:

Re: DIY Peaks Calibration Method? (Not Present Online)

Post by forestcaver » Wed Mar 25, 2020 5:57 am

Be aware that you’ll only be able to enter calibration if you have a hacked bootloader or a bootloader compiled from code that was relatively recently released (jan 2019) - or use a factory peaks....

Post Reply

Return to “Music Tech DIY”