lost in a breadboard vortex

From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!

Moderators: Kent, Joe., luketeaford, lisa

Post Reply
xaothewretched
Learning to Wiggle
Posts: 28
Joined: Sat Dec 28, 2019 6:55 am
Location: California
Contact:

lost in a breadboard vortex

Post by xaothewretched » Wed Mar 25, 2020 4:13 pm

Hope everyone is staying safe out there.

I've been lost in a breadboard vortex experimenting with lm358 datasheet circuits. Everything's based off the Texas instruments datasheet.

I've got the single amp square wave oscillator, the vco they have with the square/triangle output and the low pass filter.

It's been a fun little rabbit hole so I figured I'd post a picture here.
You do not have the required permissions to view the files attached to this post.
www.awayfoundpress.com
------Your Ad Here------

User avatar
andandand
Learning to Wiggle
Posts: 33
Joined: Wed Sep 09, 2015 11:15 pm
Location: Philly, yo

Re: lost in a breadboard vortex

Post by andandand » Sat Mar 28, 2020 7:30 pm

Looks good!

User avatar
bitflip
Ultra Wiggler
Posts: 948
Joined: Sun Dec 14, 2014 10:19 pm
Location: in the series of tubes

Re: lost in a breadboard vortex

Post by bitflip » Sat Mar 28, 2020 9:57 pm

Love that you're doing it on a RS electronic project kit board! Blast from the past! :tu:

User avatar
The Peasant
Common Wiggler
Posts: 188
Joined: Thu Sep 10, 2009 1:33 pm
Location: Sunny Alberta
Contact:

Re: lost in a breadboard vortex

Post by The Peasant » Mon Mar 30, 2020 8:41 am

This is what my breadboard looks like these days. Percussion ribbon controller circuit driving a full drum voice using 10 1J24B tubes. The only semiconductors in the audio signal path are two H11F1 in the VCF section.

Anybody else have any cool breadboard pictures to share?

Take care,
Doug
You do not have the required permissions to view the files attached to this post.
The Electronic Peasant

www.electronicpeasant.com

Post Reply

Return to “Music Tech DIY”