Moog Taurus II to Midi Using Arduino question

From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!

Moderators: Joe., lisa, luketeaford, Kent

Post Reply
bdjones
1-Post Wiggler
Posts: 1
Joined: Tue May 19, 2020 10:08 am

Moog Taurus II to Midi Using Arduino question

Post by bdjones » Tue May 19, 2020 10:20 am

I have a Moog Taurus II foot pedal that my friend wants a Midi out on it and also keep the output to the Taurus II Controller.

The pedal board has a 5 pin connector that goes to the Controller. I am pretty sure its sending CV signals to the Taurus Controller. I just don't know the pin outs. If it sends a Voltage i am pretty sure i can rout it to the Ardunio baord Analog in and convert that to a standard midi output.

It sure would beat tapping into the Foot pedal individual Pedal switches.

Thanks in advance for any info you can share. I am weak in electrical circuits, but descent at programming.

Post Reply

Return to “Music Tech DIY”