yeah, much agonising already... but always good to reconsider what and why. at the moment that row is centered at 1" vertically with each jack 0,125" above and below. they are spaced equidistantly between the far left and right jacks which are 'on grid' horizontally at 1" and 5" respectively...ashleym wrote: ↑Tue Jul 21, 2020 3:28 pm.....err.......not much. Nudge the quad mixer inputs if your bananas allow. You’re already a little off the usual full or half grid spacing. Do your sockets allow “one on grid, next 1/2 step along and/or 1/2 step down “ for each column? Without interfering with the mixer knobs.
I’m sure you’ve already agonised over this.
From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!
- Wiggling with Experience
- Posts: 281
- Joined: Wed Dec 17, 2008 7:31 pm
- Location: Stockholm, Sweden
I need to look into those depth controls and verify it with the Haible boards.ashleym wrote: ↑Sun Jul 19, 2020 3:06 pmAll great looking.
Constructively looking at the panels most of them have mod depth controls positive depth only. Is that correct?
For the BOCGS style panel the master divider panel doesn’t make sense stylistically or practically. Why LEDs at angles? Why not put them next to the sockets like the other sections? Also, without looking into this, why 4 sockets for each division? You’d save a column if you didn’t. I think the Sub only looks busy because of the writing below the knobs. You you need all of it? Lots of the other controls don’t have all their information below. I’m sure if asked someone here could offer suggestions for simplifying
Already fabricated the BOCGS panel, FPD really does some good work, but still wanted to comment back. The four outputs on each division of the master divider are 90 degrees out of phase which makes for some very cool uses. Its also really hypnotic to look at having the leds in a square formation. Ended up going with the busy looking Sub Oscillator, I'm a fan of having all the info on the panel. Don't want to go down the rabbit hole now looking for simpler way since there's no going back.