Getting down to C-2 on a Beatstep Pro?

Any music gear discussions that don't fit into one of the other forums.

Moderators: Joe., lisa, luketeaford, Kent

Post Reply
User avatar
Wiggling with Experience
Posts: 418
Joined: Thu Dec 04, 2014 5:19 pm

Getting down to C-2 on a Beatstep Pro?

Post by woVERTICES » Wed Dec 18, 2019 2:23 pm

I have tried to tune a step knob to C-2 on my BEATSTEP PRO...I cannot seem to be able to get to any
Minus pitches...what am I doing wrong?

Thanks for any advice!

User avatar
Wiggling with Experience
Posts: 304
Joined: Fri Feb 20, 2015 1:33 am
Location: San Franpsycho

Post by tito_tunes » Wed Dec 18, 2019 6:33 pm

Is your oscillator tuned as low as it goes? BSP only puts out positive voltages not negative so your oscillator shouldn’t have any frequency offset for best range

Common Wiggler
Posts: 176
Joined: Tue Sep 18, 2012 3:40 pm

Post by Samaepstein » Wed Dec 18, 2019 9:12 pm

i had to mess with the root note in the software editor for the BSP to get bass notes out of my osillators. I hope this helps

Veteran Wiggler
Posts: 696
Joined: Wed Jul 11, 2012 2:40 pm

Post by Xmit » Thu Dec 19, 2019 8:44 am

yep - same... as has every other BSP user I know & have spoken to about it.

the initial settings when connected to my MS-20M and Mother-32 were causing all the dogs in the neighbourhood to go apeshit.... :hihi:

ran the software & notched the base note down - all good now.

Post Reply

Return to “General Gear”