Both BC550B or BC550C can be used in this project.
Problem with Euro Sequencer Cv out 1 and some other issues.
Moderators: Kent, Synthbuilder
-
Synthbuilder
- Super Deluxe Wiggler
- Posts: 3009
- Joined: Tue Mar 24, 2009 9:12 am
- Location: Cumbria, UK
Re: Problem with Euro Sequencer Cv out 1 and some other issues.
-
djthopa
- Super Deluxe Wiggler
- Posts: 1825
- Joined: Thu Mar 22, 2012 5:48 pm
- Location: Somewhere between a nappy and a wire
Re: Problem with Euro Sequencer Cv out 1 and some other issues.
Hi Tony,
Its was the same mistake from the controller board.......resistor networks had pin1 inverted.
Manage to desolder both witout causing damage to the board or the resistor network, soldered them back and its all working how its meant too.
Thanks a lot for your support and for helping me out nail this one down....nearly gave up there!
Have a good weekend and thanks again
Ps: I’m going to call this module Black Phillip
Its was the same mistake from the controller board.......resistor networks had pin1 inverted.
Manage to desolder both witout causing damage to the board or the resistor network, soldered them back and its all working how its meant too.
Thanks a lot for your support and for helping me out nail this one down....nearly gave up there!
Have a good weekend and thanks again
Ps: I’m going to call this module Black Phillip