Universal Bus-/distributionboard BOM

Discussion and support for STG Soundlabs modules of all formats.

Moderators: Kent, suitandtieguy

Post Reply
User avatar
AnalogueNietzsche
Learning to Wiggle
Posts: 10
Joined: Fri Aug 28, 2015 3:34 am
Location: Sverige

Universal Bus-/distributionboard BOM

Post by AnalogueNietzsche » Fri Oct 14, 2016 4:23 pm

Hi Everyone,

Does anyone have the BOM for the STG-busboards? I know it's not much on them but I should especially need the values for the capacitors.

sincerely,
AN

ualslosar
Wiggling with Experience
Posts: 324
Joined: Wed Mar 24, 2010 5:42 pm
Location: West Coast, USA

Post by ualslosar » Wed Oct 19, 2016 5:43 pm

Unaware of any BOM, but the distro board from STG uses 100mF 50V electrolytic caps. I have one installed in my system & it works great.

In addition to STG, Analog Craftsmen, BLACET, Grove Audio & others all make distro boards

Regards
Larry

User avatar
AnalogueNietzsche
Learning to Wiggle
Posts: 10
Joined: Fri Aug 28, 2015 3:34 am
Location: Sverige

Post by AnalogueNietzsche » Thu Oct 20, 2016 10:22 am

Great! Thanks for the reply! I have four of them, they have been laying around unmounted for over a year. Guess I can start building. Nice, and thx again!

Sincerely,
AN

ualslosar wrote:Unaware of any BOM, but the distro board from STG uses 100mF 50V electrolytic caps. I have one installed in my system & it works great.

In addition to STG, Analog Craftsmen, BLACET, Grove Audio & others all make distro boards

Regards
Larry

Post Reply

Return to “STG Soundlabs”