Trouby Math Sequencer in Modcan A?

Controllers for Moog format systems - official discussion & support.

Moderators: Kent, trouby

Post Reply
User avatar
SunSpots
Super Deluxe Wiggler
Posts: 2583
Joined: Sun Jun 19, 2011 1:04 pm
Location: Northern California

Trouby Math Sequencer in Modcan A?

Post by SunSpots » Fri Sep 30, 2011 12:27 pm

Trouby,

I tried PMing you, but maybe it was lost.

I was wondering if you could do the same unit but with a Modcan A sized panel and bananna jacks? I have a huge box and I want to try to get your unit into the box. I don't mind paying a little more for the customization. I think all the wiring/electronics would be the same?
+/- 5V?

SunSpots
SunSpots

User avatar
trouby
Common Wiggler
Posts: 77
Joined: Mon Jun 28, 2010 10:49 am

Post by trouby » Tue Oct 04, 2011 8:04 am

only +12 or +15V, 5V regulator on module.
GO or RESET signal?

User avatar
SunSpots
Super Deluxe Wiggler
Posts: 2583
Joined: Sun Jun 19, 2011 1:04 pm
Location: Northern California

Post by SunSpots » Tue Oct 04, 2011 3:18 pm

Are you saying there's *no* 5V regulator on module, or there is?

And I'm not sure what you're asking about the GO/RESET signals? Are you talking about the gate on/off? I believe it's all +/- 5V in Modcan... correct me if I'm wrong.

I also mentioned this in the email, but a CV controllable jack to control the two math numbers would be awesome!

SunSpots
SunSpots

User avatar
trouby
Common Wiggler
Posts: 77
Joined: Mon Jun 28, 2010 10:49 am

Post by trouby » Wed Oct 05, 2011 5:58 am

for sure there is a 5V regulator on module.
Gate and lot of CV is 0-5V.

GO (start/stop) & Reset are gates to start & stop the sequencer.
GO=1 (dotcom) or Reset=0 starts the sequencer.

banana jacks: black, blue, green, red are avail. - this 4 colors should be a jack row.

Post Reply

Return to “Trouby Modular ”