Building the AMS8060 - Issues

Discussion and support for the AMSynths range of analog synthesizer modules.

Moderators: Kent, emuarc

Post Reply
User avatar
Veteran Wiggler
Posts: 585
Joined: Thu Nov 27, 2014 2:31 am
Location: Kuala Lumpur

Building the AMS8060 - Issues

Post by oscarthesquirrel » Sat Jul 11, 2015 7:32 am

Started building the AMS8060 today and have noted a few issues.

1. the BOM is NOT fully correct. R38 and R40 are missing (luckily the build notes has the schematic which tells you what they are).

2. The aluminium panel I bought from AMS has pretty large jack holes...too large in fact for most of my jacks. Have gone to using some Erthenvar jacks whose diameter appears to fit.

3. There are 3 versions of the build docs on the web. I accidentally logged into V1.0, but then went to 2.2 and 2.3 All of them were on AMS sites. Its a bit confusing as links from and seem to point to different build docs. This meant I started populating the board with 100K resistors in the wrong positions...grrr..and had to desolder 8 resistors. At least the board is lovely to work with.

My bete-noire is wiring. I'm using the pots PCB as well as the main PCB, so lets see how long it is before I scream for help, despite the wiring notes. Jacks always confuse me.
"You can never have too many LFO's..."

Post Reply

Return to “AMSynths”