Galilean Moons (DIY) troubleshooting

Discussion for Hexinverter eurorack modules - email Hex if you need anything urgent!

Moderators: Kent, hexinverter

Post Reply
User avatar
ilya.n
Common Wiggler
Posts: 141
Joined: Wed Oct 01, 2014 7:57 pm
Location: Sydney, Australia

Galilean Moons (DIY) troubleshooting

Post by ilya.n » Thu Sep 10, 2015 5:44 pm

Hi,

I have a Storm and Moons (DIY) connected via expander cable. The modules had been working OK until I did some rack re-arrangement yesterday.

The issue is that I am getting very very weak output from VCA 2 when using expander connection i.e. when no jack is plugged into VCA 2 IN. When I plug the signal into VCA2 all is working fine. VCA 1 and XOR OUT are all good.

Any advice what to look at is appreciated.

Thanks!

User avatar
ilya.n
Common Wiggler
Posts: 141
Joined: Wed Oct 01, 2014 7:57 pm
Location: Sydney, Australia

Post by ilya.n » Tue Sep 15, 2015 6:50 am

Well, it started working after i took the panel off and pushed all ICs firmer in their sockets... Don't know what was it...

Post Reply

Return to “Hexinverter Electronique”