mutant hot glue compression problem

Discussion for Hexinverter eurorack modules - email Hex if you need anything urgent!

Moderators: Kent, hexinverter

Post Reply
bruital
Learning to Wiggle
Posts: 8
Joined: Thu Dec 03, 2015 4:34 am
Location: france

mutant hot glue compression problem

Post by bruital » Wed Dec 16, 2015 11:18 am

hello

i just finish to built my mutant hot glue!

every thing is ok but compression is out:

i have calibrate it but the comp made a very bad distorsion with a gain of 0 to +20db and after nothing!!!



have you an idea?

thanks

bruital
Learning to Wiggle
Posts: 8
Joined: Thu Dec 03, 2015 4:34 am
Location: france

Post by bruital » Tue Dec 22, 2015 5:47 am

so i have a problem with the comp : the sound distort a lot with a little gain, and shut down with a middle gain (like too much of gain)

i check the sound on the that 4301, the sound distort at the output of the VCA ( pin 13).

on the pin EC- (16) of the that 4301, i mesure 0v with 0 gain and -2.3v at max gain.
the sound stop at -0.59V.

are this values normal or it's to big???

magiseoane
Learning to Wiggle
Posts: 5
Joined: Thu Dec 10, 2015 9:05 am
Location: Tarragona

I have the same problem....

Post by magiseoane » Thu Feb 11, 2016 3:58 am

I have the same problem....
:despair: :despair: :despair: :despair: :despair:

Post Reply

Return to “Hexinverter Electronique”