909 808 raw noise into mutant hihats

Discussion for Hexinverter eurorack modules - email Hex if you need anything urgent!

Moderators: Kent, hexinverter

Post Reply
maccadelic
Learning to Wiggle
Posts: 21
Joined: Fri Nov 27, 2015 11:08 pm
Location: Melbourne, Australia

909 808 raw noise into mutant hihats

Post by maccadelic » Wed May 11, 2016 3:57 pm

I have a full set of the diy 909 close and the 808 toms. I am currently topping it all off with mutant hi hat. I was just wandering if i could take the raw output from the 909 and 808 noise cards, wire them through an attenuator and into jacks on a panel. If this is possible I could then use these for the noise input on the mutant hihats.

If this is possible, would a 100k pot be fine for the job?

Thanks

Post Reply

Return to “Hexinverter Electronique”