Problem with Mutant Clap DIY

Discussion for Hexinverter eurorack modules - email Hex if you need anything urgent!

Moderators: Kent, hexinverter

Post Reply
User avatar
Doc L Junior
Learning to Wiggle
Posts: 22
Joined: Thu Jan 14, 2016 2:28 am
Location: Oslo, Norway
Contact:

Problem with Mutant Clap DIY

Post by Doc L Junior » Fri Dec 15, 2017 7:32 am

I wrote this as a comment in another topic but I'm trying again with a fresh start:

"Hi,

I had a perfectly working Mutant Clap until today. Now I have constant noise from all three outputs and it does not react to any trig signal - no blinking trig led.
I have no idea what could have caused this - nothing special has been patched into it ad I haven't had any power issues.
I would really appreciate if someone could guide me in troubleshooting this one.

So far I have checked the trig in jack but it seems fine. I have also examined all solder joints and gave some of them a reflow."

Hope someone can help me out. Love that module.
Any sufficiently advanced magic is indistinguishable from technology
This is my Soundcloud profile

Decurion99
Learning to Wiggle
Posts: 9
Joined: Sat May 13, 2017 10:05 pm
Location: Zurich

Post by Decurion99 » Sat Jan 06, 2018 6:13 pm

Has this been fixed? Somebody today told me their mutant clap has also a noise issue!

Post Reply

Return to “Hexinverter Electronique”