seqSQUARED Assembly Help Thread

Discussion for Hexinverter eurorack modules - email Hex if you need anything urgent!

Moderators: Kent, hexinverter

User avatar
the nettles make me think happy times
Posts: 2968
Joined: Thu Aug 25, 2011 8:48 pm
Location: Montreal, Canada

Re: New tune in progress

Post by hexinverter » Thu May 23, 2013 11:12 pm

bkbirge wrote:Here's a demo tune based around the SympleSeq run through the SeqSquared and triggering an MFB Kraftzwerg euro module. Plus some other hot pants action...

The SeqSquared is a lot of fun with a pair of dual SympleSeq's, just flipping on/off switches while the sequencers are running and combining with the variable de-multiplexing of the SeqSquared yields a *lot* of possibilities.
Nice!!! Thanks for sharing man! :tu:
Hexinverter Électronique
em: stacy[at]

User avatar
Learning to Wiggle
Posts: 13
Joined: Thu Jul 25, 2013 7:11 pm
Location: California

Post by peff » Thu Sep 19, 2013 3:12 pm

ah i should have read this thread first. I too had the problem with the Gate.D jack shorting the CV.D trace to ground.

I've also been experimenting with the yellow LED current resistors by tacking in different values in parallel with the 20k network. 2.8k seems a little too bright, but a 7.8k seems about right. In theory this shouldn't be a problem, but is it better to just bypass the resistor network completely?

User avatar
Posts: 6341
Joined: Fri Aug 06, 2010 8:05 pm
Location: Limerick, Ireland

Post by mckenic » Sun Nov 16, 2014 8:47 pm

Wish I saw that!
Wow you must be excited!

Post Reply

Return to “Hexinverter Electronique”