Problem uploading Ardcore sketches

Discussion and Support for our Atmospheric Modification Devices.

Moderators: Kent, loss1234

Post Reply
User avatar
JoeFuture
Wiggling with Experience
Posts: 275
Joined: Mon May 23, 2016 3:57 pm
Location: the void

Problem uploading Ardcore sketches

Post by JoeFuture » Sun Mar 19, 2017 2:41 pm

I keep getting this error when I try to upload new sketches:

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding

It tries 10 times, then gives up. I know I'm on the right serial port because the previous sketch is writing out to the serial lines to indicate which note it's playing (a quantizer sketch I modified).

Any ideas?

User avatar
JoeFuture
Wiggling with Experience
Posts: 275
Joined: Mon May 23, 2016 3:57 pm
Location: the void

Post by JoeFuture » Sun Mar 19, 2017 4:26 pm

OK, solved it myself. I had the wrong Arduino selected in the IDE. After switching it to the UNO board, all is well.

Post Reply

Return to “SNAZZY FX”