Power Requirements

Discussion, support, and resources for our noise making modules and kits.

Moderators: Kent, scottwilson

Post Reply
User avatar
dadek
hrrmmm...
Posts: 773
Joined: Fri Aug 15, 2008 12:25 am
Location: SoCal

Power Requirements

Post by dadek » Sun Jul 27, 2014 11:50 am

Finally getting around to unpacking and setting up this beast.

I admit to being not so tapped in to all the finer points of power in Euro. Does this thing require anything special? I don't have any other module that comes close to it in size or weight.

I can place it in Doepfer A100 G6 [+/-12 v/ 1200 ma (known as the psu2)] or a Doepfer Monster Case. [max. module current: 4.8a (four power supplies 1.2a each, one power supply is assigned to two bus boards)]

Is it just plug and play with these?

:guinness: TIA.

User avatar
scottwilson
Wiggling with Experience
Posts: 435
Joined: Mon Sep 16, 2013 12:54 pm

Post by scottwilson » Sun Jul 27, 2014 11:58 am

Yes, you won't have any issues with that power supply. It only requires +/- 12V, no 5V required. Reports are that at idle, it's about 200mA, and the only big draw above idle is the LEDs which, even when they are all full-blast will only be about 100mA more.

I've used it with my 9U A-100 power supply, a uZeus, and a pittsburgh Cell 48, all with no issues.

There was one user who was having an issue with the uZeus, but it was a bad power cable which was replaced.

s

User avatar
dadek
hrrmmm...
Posts: 773
Joined: Fri Aug 15, 2008 12:25 am
Location: SoCal

Post by dadek » Sun Jul 27, 2014 4:51 pm

sweet, time to get to it then. thanks!! :guinness:

Post Reply

Return to “nw2s”