io ribbon cable

Discussion, support, and resources for our noise making modules and kits.

Moderators: Kent, scottwilson

Post Reply
User avatar
ipassenger
Veteran Wiggler
Posts: 707
Joined: Fri Jun 10, 2011 3:19 am

io ribbon cable

Post by ipassenger » Fri Jan 10, 2020 1:21 pm

yo!

Just got two of these and now I have 16 channel mixer with eqs and aux send for modular (mackie 1604) Boom!

Anyway one question I have is, how rough can i be with the ribbon cables that joins the two boards together? I have unbalanced versions and I'd like em both flush with the right sides of my case (in different rows of course) but I don't want to break the ribbon cables or connectors to get them that close.

At the minute I have a little over a 1hp gap to leave room for the cable.
image0 (1).jpeg
image0 (1).jpeg (1.88 MiB) Viewed 676 times
Thanks.

User avatar
seank
Wiggling with Experience
Posts: 499
Joined: Thu Aug 25, 2011 9:05 pm
Location: los angeles
Contact:

Re: io ribbon cable

Post by seank » Tue Feb 04, 2020 8:40 pm

they'll sit flush with the edge if you "fold" the ribbon cables in. i have had balanced and unbalanced versions of the io and you always have to push in on the center of the ribbon cable to get it to push in.

User avatar
ipassenger
Veteran Wiggler
Posts: 707
Joined: Fri Jun 10, 2011 3:19 am

Re: io ribbon cable

Post by ipassenger » Thu Feb 06, 2020 1:05 pm

Thanks, got it within 1hp but going to leave it there for now. :hihi:

Post Reply

Return to “nw2s”