Page 1 of 1

io ribbon cable

Posted: Fri Jan 10, 2020 1:21 pm
by ipassenger
yo!

Just got two of these and now I have 16 channel mixer with eqs and aux send for modular (mackie 1604) Boom!

Anyway one question I have is, how rough can i be with the ribbon cables that joins the two boards together? I have unbalanced versions and I'd like em both flush with the right sides of my case (in different rows of course) but I don't want to break the ribbon cables or connectors to get them that close.

At the minute I have a little over a 1hp gap to leave room for the cable.
image0 (1).jpeg
image0 (1).jpeg (1.88 MiB) Viewed 621 times
Thanks.

Re: io ribbon cable

Posted: Tue Feb 04, 2020 8:40 pm
by seank
they'll sit flush with the edge if you "fold" the ribbon cables in. i have had balanced and unbalanced versions of the io and you always have to push in on the center of the ribbon cable to get it to push in.

Re: io ribbon cable

Posted: Thu Feb 06, 2020 1:05 pm
by ipassenger
Thanks, got it within 1hp but going to leave it there for now. :hihi: