DIY kit?

Support and discussion of Tubbutec products.

Moderators: Kent, tubbutec

Post Reply
User avatar
Kan Kaban
Learning to Wiggle
Posts: 40
Joined: Thu Dec 08, 2011 11:47 pm

DIY kit?

Post by Kan Kaban » Mon Jul 02, 2018 9:25 pm

First of all congrats for this product, I needed this module. Are u selling any DIY kit or similar for the module and cv extensions? Thanks

User avatar
tubbutec
Veteran Wiggler
Posts: 559
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Post by tubbutec » Tue Jul 03, 2018 3:51 am

No,
µTune is now only available as completely assembled
version.
We were thingking about offering a DIY version, but it would not have been cheaper.

On request we can offer µTune w/o front panel for those who want to spin their own panel.

mmeixner
Common Wiggler
Posts: 126
Joined: Tue Aug 09, 2016 9:27 am
Location: Austria

Post by mmeixner » Wed Aug 22, 2018 12:27 pm

tubbutec wrote:No,
µTune is now only available as completely assembled
version.
We were thingking about offering a DIY version, but it would not have been cheaper.

On request we can offer µTune w/o front panel for those who want to spin their own panel.

I'm just working on a 5U version of µTune. In this case it would be easier to get a complete module, but WITHOUT the jacks soldered in

User avatar
tubbutec
Veteran Wiggler
Posts: 559
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Post by tubbutec » Thu Aug 23, 2018 4:48 am

I'm just working on a 5U version of µTune. In this case it would be easier to get a complete module, but WITHOUT the jacks soldered in
All units have their sockets installed already (+ we also need the sockets for testing and calibration). We can however offer to desolder the sockets for you. Please contact us via mail.

Post Reply

Return to “Tubbutec”