Page 1 of 1

[SH-1oh1] Request - Better Control for Slower LFO Speeds

Posted: Thu Dec 13, 2018 4:46 am
by Seaweed Sound
The manual says the slowest LFO speed is 0.12 Hz (~8 seconds per cycle).

In practice with minimum settings on the internal LFO (Coarse=0, Fine=0) on my unit it is ~2 seconds.

Can there be better control over slower LFO speeds? Maybe a LFO low/high range switch?

The way the Coarse/Fine interact seems odd. With Coarse=0 and Fine=127 it's already into audio rate modulation.

I'm trying to get slow PWM from the stock LFO and slow filter modulation from the software LFO for evolving sequences etc.

Posted: Fri Dec 14, 2018 10:47 am
by tubbutec
Thanks for reporting this, should of course be like in the manual. My guess is that a later update changed the LFO update rate and thus the minimum speed. Will look into this and publish a fix.

Posted: Sun Dec 16, 2018 8:00 pm
by Seaweed Sound
If it helps I'm running v1.04. I'm hoping it could be made to go even slower than the 8 seconds listed in the manual.

Posted: Tue Mar 19, 2019 11:02 pm
by Seaweed Sound
Perhaps this could be tackled during MC-2oh2 development (assuming similar LFO code?)

Posted: Wed May 22, 2019 2:49 pm
by Surfermax
Seaweed Sound wrote:If it helps I'm running v1.04. I'm hoping it could be made to go even slower than the 8 seconds listed in the manual.
That would be awesome. I think I cannot even get 2 secs. 8 would be great