Roland CR-800

Support and discussion of Tubbutec products.

Moderators: Kent, tubbutec

Post Reply
torismad
Learning to Wiggle
Posts: 2
Joined: Fri May 22, 2020 10:45 am
Location: Florida

Roland CR-800

Post by torismad » Fri May 22, 2020 11:00 am

Hi, I have a Roland CR-800 and I was wondering if the Uni-Pulse midi kit for the CR-78 would work on this machine as well ?

Any help would be greatly appreciated.

Thanks
https://encyclotronic.com/drum-machines ... r-800-r72/

User avatar
tubbutec
Veteran Wiggler
Posts: 660
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Re: Roland CR-800

Post by tubbutec » Sun May 24, 2020 1:34 am

You will definitely be able to trigger sounds. However without schematics it is hard to say from here. A synth tech would definitively be able to find the trigger points and install uniPulse.
Quite likely the CR-800 uses the same sound board as the CR-68. If you can post some pictures of the board inside, I can probably help better.

torismad
Learning to Wiggle
Posts: 2
Joined: Fri May 22, 2020 10:45 am
Location: Florida

Re: Roland CR-800

Post by torismad » Fri Jun 12, 2020 7:04 pm

Here is a few pics
Attachments
29B3725C-257B-4471-A943-F8A93646930C.jpeg
55ECCD62-065E-4565-9F16-BA4557BF934E.jpeg

User avatar
tubbutec
Veteran Wiggler
Posts: 660
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Re: Roland CR-800

Post by tubbutec » Wed Jun 24, 2020 9:31 am

I believe this is in fact the Cr-78 voice board. You can compare it to the pictures on page 6 and 7 in out installation manual:
https://tubbutec.de/files/uniPulseConfi ... lation.pdf

You should be able to connect uniPulse at the very same points and trigger the sounds.

Post Reply

Return to “Tubbutec”