uTune MIDI clock to CV

Support and discussion of Tubbutec products.

Moderators: Kent, tubbutec

Post Reply
honkfink
Learning to Wiggle
Posts: 7
Joined: Fri Nov 29, 2019 8:30 am
Location: Sydney

uTune MIDI clock to CV

Post by honkfink » Thu May 28, 2020 10:32 pm

Is this feature broken on 2.01 and 2.02? I have got this working before going DIN to CV from octatrack. Have checked that MIDI gate and internal clock can output signal OK. MIDI clock definitely coming from octatrack and showing up on uTune MIDI monitor. Clock routing is set as DIN to CV. Have updated to FW 2.02 and reset. This behaviour happens on uTune and expander module gate output. I'm not sure what else I can do. Can you reproduce?
Top
honkfink
Learning to Wiggle
Posts: 7
Joined: Fri Nov 29, 2019 8:30 am
Location: Sydney

Re: uTune MIDI clock to CV

Post by honkfink » Fri May 29, 2020 2:00 am

Solved, needed to enable transport send on octatrack.
Top
Post Reply

Return to “Tubbutec”