Juno-66, nanoKontrol2, USB - DIN5 Midi

Support and discussion of Tubbutec products.

Moderators: Kent, tubbutec

Post Reply
inorx
Learning to Wiggle
Posts: 9
Joined: Sat Jul 14, 2018 6:03 pm

Juno-66, nanoKontrol2, USB - DIN5 Midi

Post by inorx » Thu Dec 31, 2020 6:02 pm

Hi all

until now i have used a nanoKontrol2 via USB/PC to control the Juno-66. All good so far.

Now I'm looking for a smart way to directly connect the nanoKontrol2 to the Juno-66 Midi-in without the need for a PC. As far as i understand, some kind of a USB Host would be needed, offering USB und DIN5 Midi Interfaces. Potentially something like:
I would prefer a smaller and a less expensive box. I was thinking about building something based on an Arduino board or use something like this as a base: https://www.hobbytronics.co.uk/usb-host ... -board-v24

As I might not be the first one thinking about directly connecting a nanoKontrol2 to the Juno-66, I'd like to ask which solutions you came up with, which products/solutions you have made good experiences or bad experiences with? Any feedback, input, hint is very appreciated.

Thankt a lot and happy new year!

User avatar
tubbutec
Veteran Wiggler
Posts: 697
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Re: Juno-66, nanoKontrol2, USB - DIN5 Midi

Post by tubbutec » Fri Jan 01, 2021 9:32 am

Hi,
if you have a Eurorack case, we can only recommend our USB Bridge A for this:
https://tubbutec.de/usb-bridge-a/

With an inexpensive adapter cable from TRS midi to DIN midi, you can directly connect the Juno and the nanoKontrol

Don't have any experience with the other solutions though

Post Reply

Return to “Tubbutec”