Juno 6 Major Bend Offset

Support and discussion of Tubbutec products.

Moderators: Kent, tubbutec

Post Reply
User avatar
Synthwizard
Learning to Wiggle
Posts: 10
Joined: Sun May 29, 2016 6:28 pm
Location: Los Angeles
Contact:

Juno 6 Major Bend Offset

Post by Synthwizard » Wed Mar 17, 2021 2:31 pm

Hi all,
We've installed what seems like a million of these and never had this issue.
Juno 6 bend offset is excessive. I've double checked the install my tech did and the R values are all correct, no shorts etc.

When the DCO amount slider is turned up, the synth bends up about a 5th or more. Way beyond the usual calibration needed. The pot is centered and in dead zone.

Any idea?

Thanks
Rob
Owner of Rosen Sound in Burbank, California. www.rosensound.com

User avatar
tubbutec
Veteran Wiggler
Posts: 723
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Re: Juno 6 Major Bend Offset

Post by tubbutec » Fri Mar 19, 2021 3:29 am

Hi,
please contact support (at) tubbutec.de
All the best
T

Post Reply

Return to “Tubbutec”