MULT strange behavior

[cordoba899]

Hi folks,

I am having some trouble with my MULT build. I was going for the buffered version. It powers up nicely, and the input signal gets multipled - but only from jack A to jack B (the one right to the input). The two jacks below do not give any signal except for when i pull out the cable around halfway, then the signal is perfect. Weirdly though, the last set of 4 jacks works as intended for all 4 jacks. One thing I did is, because I used kubiconn jacks, I combined sets of 2 jacks to a common ground and left one of the ground holes unused - could this have caused this behavior? Any other obvious mistakes I could have made? Thanks for your help!

Cheers

[antumbra]

Hi, all jacks should be connected to gnd, I’m not sure what kubiconn jacks are, and what quality they could be. I’d try swapping them to thonkiconns and see if it works.