Anybody else notice this?


I'd double-check resistor values for that channel. It sounds like you have a voltage offset.itchaboo wrote:I finished mine this weekend, it is a presoldered smd kit by pusherman.
I have an issue with channel number 3 that I'm trying to troubleshoot. It does not distort but the output voltage only goes up to +8.8v, but down to -10v as expected. Also the led on channel 3 flips from green to bright red once I go past 1.1v output voltage but it goes from brigt red to dark (-10v to 0v) just fine.
It gets fairly warm, I measured ~50°C for each of the ICs (came with LME49743) which should be fine.