Power cable question

Dedicated forum for the MMM synth modules, both production and DIY units.

Moderators: Kent, mmm

Post Reply
User avatar
pugix
Super Deluxe Wiggler
Posts: 3368
Joined: Sat Oct 31, 2009 7:23 am
Location: Asheville, NC
Contact:

Power cable question

Post by pugix » Mon May 10, 2010 8:39 pm

I'm planning on putting two DIY boards behind one panel. I use the 4-pin MOTM power connector to connect the supply. I was wondering if the Power Cable 6P-6P can be used to run power from one Mattson board to the other.
Richard
http://www.pugix.com

"Everything in our world is actually always modulated by everything else." - Peter B

mmm
yummm!
Posts: 779
Joined: Mon Oct 27, 2008 7:45 pm
Location: Western Washington

Re: Power cable question

Post by mmm » Mon May 10, 2010 9:26 pm

pugix wrote:I'm planning on putting two DIY boards behind one panel. I use the 4-pin MOTM power connector to connect the supply. I was wondering if the Power Cable 6P-6P can be used to run power from one Mattson board to the other.
Absolutely.

User avatar
pugix
Super Deluxe Wiggler
Posts: 3368
Joined: Sat Oct 31, 2009 7:23 am
Location: Asheville, NC
Contact:

Post by pugix » Tue May 11, 2010 6:57 pm

I ordered a couple of 6P-6P cables! Thanks.

Now I see the advantage to having both types of power connector on each board.
Richard
http://www.pugix.com

"Everything in our world is actually always modulated by everything else." - Peter B

mmm
yummm!
Posts: 779
Joined: Mon Oct 27, 2008 7:45 pm
Location: Western Washington

Post by mmm » Tue May 11, 2010 7:18 pm

pugix wrote:I ordered a couple of 6P-6P cables! Thanks.

Now I see the advantage to having both types of power connector on each board.
:headbang:

Post Reply

Return to “Mattson Mini Modular”