MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Adding output clipping diodes to the R3 PB
MUFF WIGGLER Forum Index -> Flight of Harmony  
Author Adding output clipping diodes to the R3 PB
haima
Hey - I've got a R3 Plague Bearer on it's way from BST forum.

I'd love to add some output clipping diodes ala the current R4 version...

Does anyone know what kind of diodes are used in the R4?

2 zeners, to the power rails as a passive circuit on the output? with a series resistor?

I'll have a play around and come up with my own version - unless anyone has some tips on what's in the real deal.
EarlJemmings
The real deal is blasting your face and speakers off with the full unencumbered glory of the Plague Bearer shriek
HeWhoWantsJeans
EarlJemmings wrote:
The real deal is blasting your face and speakers off with the full unencumbered glory of the Plague Bearer shriek

I like the way you think. hihi

As per the OP, I do not know the information requested. I'll reach out to Flight and see what I can find. thumbs up
haima
thanks guys!

I just got the PB - it's fun! screaming goo yo
EarlJemmings
I'm not sure if it's just a faulty module, but the Rev4 plague bearer I played with was absolutely thin and wimpy and nothing like my rev 3. Anybody have both and can say if this is a universal case?
MUFF WIGGLER Forum Index -> Flight of Harmony  
Page 1 of 1
Powered by phpBB © phpBB Group