Attaching Blacet dist. board to Paia rack?

Blacet, Metalbox, Synthasonic, PAiA and the rest.... a frac frenzy!

Moderators: luketeaford, Joe., lisa, Kent

Post Reply
Sir Ruff
Super Deluxe Wiggler
Posts: 1872
Joined: Tue Jun 02, 2009 6:23 pm
Location: Philadelphia
Contact:

Attaching Blacet dist. board to Paia rack?

Post by Sir Ruff » Mon Jan 25, 2010 2:08 pm

As the title states, I'm going to be looking to mount a blacet distribution board onto a paia rack. I'm not sure what the latter's layout is like-are there any places to screw on the dist. board, or will this have to be some sort of DIY affair?

User avatar
johnnymad
turbo wiggler
Posts: 1113
Joined: Wed Jul 09, 2008 9:55 pm
Location: Baton Rouge, Louisiana

Post by johnnymad » Mon Jan 25, 2010 6:13 pm

not sure about the paia, but i have your rack, psu, and distro all packed up and ready to go. i'll ship it out tomorrow!

Sir Ruff
Super Deluxe Wiggler
Posts: 1872
Joined: Tue Jun 02, 2009 6:23 pm
Location: Philadelphia
Contact:

Post by Sir Ruff » Tue Jan 26, 2010 11:27 am

johnnymad wrote:not sure about the paia, but i have your rack, psu, and distro all packed up and ready to go. i'll ship it out tomorrow!
sweet (couldn't find thumbs up so this will have to suffice) :rock:

User avatar
johnnymad
turbo wiggler
Posts: 1113
Joined: Wed Jul 09, 2008 9:55 pm
Location: Baton Rouge, Louisiana

Post by johnnymad » Tue Jan 26, 2010 4:04 pm

she's in route. load her up with modules when she gets there.

Post Reply

Return to “Fractional Rack Modules”