MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Presenting: Crowminius
MUFF WIGGLER Forum Index -> Music Tech DIY Goto page Previous  1, 2, 3 ... 38, 39, 40 [all]
Author Presenting: Crowminius
Troubleshooter
p4rancesc0 wrote:
Hi,
sorry to bother but is there any chance to get in Europe (Italy) this opto coupler ?

PC900V0NSZXF

Even a replacement would be fine if there's any...

Thx


https://www.conrad.nl/nl/optocoupler-fototransistor-sharp-pc-900-dip-6 -open-collector-dc-184098.html

or EBAY like I did
colorbars
For anyone who's interested I'm selling my crowminius from the first run of boards here for roughly what it cost me to build...

https://www.muffwiggler.com/forum/viewtopic.php?t=187530

Hope it's ok to post this here, if not please delete screaming goo yo
Godric
I carried this error forward onto my panel and didn't notice it until after fabrication - sigh!


oldcrow wrote:

To answer this question this was me forgetting to change the panel graphic to the reverse saw on osc3. This is only on a few of my early panels.

Crow
/**/

Troubleshooter wrote:
A question, some half of the crowminius fronts I have seen have the reverse saw on OSC3 the other half have the 3 times the same saw/tri mixed waveform. Wich one should I engrave for the rev.3 board?
stringsthings
I'm at the stage where I'm doing the mass of offboard wiring for my Crowminius build. I've got a question for the people who have finished their build ( or almost finished ). Did you need to use shielded wire for any of the offboard pots, switches, or jacks?

I can see the possiblility of shielding the wires to the outputs ( jack, pot, switch ). But if I don't have to shield, I won't bother. Doing all the pots and switches and jacks is enough of a headache.
Troubleshooter
I am about 50% done in wiring mine and took the risk to not shield anything. I will put my AC transformer in an external box however.
I never shielded anything in my DIY stuff except for a few cases (tube
guitar amps, backlit LCD displays close to audio chains, etc...). Since my cabeling is longer than usual also I don't really know what to expect. Fingers crossed.

stringsthings wrote:
I'm at the stage where I'm doing the mass of offboard wiring for my Crowminius build. I've got a question for the people who have finished their build ( or almost finished ). Did you need to use shielded wire for any of the offboard pots, switches, or jacks?

I can see the possiblility of shielding the wires to the outputs ( jack, pot, switch ). But if I don't have to shield, I won't bother. Doing all the pots and switches and jacks is enough of a headache.
MUFF WIGGLER Forum Index -> Music Tech DIY Goto page Previous  1, 2, 3 ... 38, 39, 40 [all]
Page 40 of 40
Powered by phpBB © phpBB Group