mods for an SH-2

From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!

Moderators: Joe., luketeaford, lisa, Kent

Post Reply
User avatar
Let's go do some crimes
Posts: 1516
Joined: Mon Aug 25, 2008 8:26 pm
Location: Southern California

mods for an SH-2

Post by justin3am » Wed Mar 24, 2010 4:41 pm

I just picked up a Roland SH-2 and I'd like to know if anyone has modded it for CV control of the filter, osc sync, FM and that kind of stuff. If so, has anyone documented their modifications?

I did some half-assed google searching but I figure that I may get some more direct answers here.

Thanks! :tu:
"Thank god for the drugs and drums." El-P
3amNoise | Synth Videos

User avatar
still learning to wiggle
Posts: 4356
Joined: Tue Aug 04, 2009 7:15 am
Location: Rotterdamm son

Post by falafelbiels » Wed Mar 24, 2010 7:25 pm

Well if there is a mixer section for the cutoff then you can do the one from the SH-101 novamod, which is the easiest mod I've ever seen and done. It takes just a socket, a resistor and some wire to the point on the board where the other modulation sources meet. :tu:

Post Reply

Return to “Music Tech DIY”