MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

SH1oh1 vco calibiration
MUFF WIGGLER Forum Index -> Tubbutec  
Author SH1oh1 vco calibiration
isak
Hi guys smile

After installing the sh1oh1 the SH is out of tune.
I must add i replaced the power switch.
Ive tuned more then 10 sh's in my life, for some reason i cant tune this one after the mode.
I get 5.1V from the cpu pin 40.
Can you please advise

Cheers,
Isak.
tubbutec
Hi,

at which point during the tuning does it fail?

Please also try the following: Disconnect the green CV wire (pitch bend cv). Perform the tuning. Then reconnect it and perform the pitch bend calibration.

You can also put the original CPU back in - can you tune it now?
isak
thank you for fast reply.
sadly i can test only in the weekend.
i'll try what you suggest and update as soon as i can.
much appreciate the help.

have a great week smile

isak.
isak
Have another Q please.

The 2 resistors that located from the solder part of the cpu, should i remove them when replacing the cpu to the your cpu?

MUFF WIGGLER Forum Index -> Tubbutec  
Page 1 of 1
Powered by phpBB © phpBB Group