MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Power cable question
MUFF WIGGLER Forum Index -> Mattson Mini Modular  
Author Power cable question
pugix
I'm planning on putting two DIY boards behind one panel. I use the 4-pin MOTM power connector to connect the supply. I was wondering if the Power Cable 6P-6P can be used to run power from one Mattson board to the other.
mmm
pugix wrote:
I'm planning on putting two DIY boards behind one panel. I use the 4-pin MOTM power connector to connect the supply. I was wondering if the Power Cable 6P-6P can be used to run power from one Mattson board to the other.


Absolutely.
pugix
I ordered a couple of 6P-6P cables! Thanks.

Now I see the advantage to having both types of power connector on each board.
mmm
pugix wrote:
I ordered a couple of 6P-6P cables! Thanks.

Now I see the advantage to having both types of power connector on each board.


headbang
MUFF WIGGLER Forum Index -> Mattson Mini Modular  
Page 1 of 1
Powered by phpBB © phpBB Group