modypoly poly-61 pitch bend?

Support and discussion of Tubbutec products.

Moderators: Kent, tubbutec

Post Reply
wonton
Learning to Wiggle
Posts: 2
Joined: Tue May 02, 2017 5:53 pm

Modypoly Poly-61 pitch bend

Post by wonton » Tue May 02, 2017 6:04 pm

Hello, I installed the Modypoly in my Poly-61 over the weekend, and I love it. Thanks Tubbutec! 8-)

Could you let me know if it is possible to control the pitch bend via MIDI? It says you can in the instructions, but so far no luck. I looked around on the website and did not see specific pitch bend installation instructions for the P61, I did see that there was a procedure for other Korg synths though. I haven't soldered the filter CV yet BTW.

Thanks and apologies in advance if I overlooked the instructions.

User avatar
tubbutec
Veteran Wiggler
Posts: 660
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Post by tubbutec » Fri May 05, 2017 1:30 pm

There is currently no known way to control the pich bender via midi with the ModyPoly. We just could not find any.
In wonder where you read it? Pretty sure there is nothing in the installation manual.
And on the ModyPoly website it clearly says:
Pitch bend Polysix and Mono/Poly only.

wonton
Learning to Wiggle
Posts: 2
Joined: Tue May 02, 2017 5:53 pm

Post by wonton » Tue May 09, 2017 2:17 pm

tubbutec wrote:There is currently no known way to control the pich bender via midi with the ModyPoly. We just could not find any.
In wonder where you read it? Pretty sure there is nothing in the installation manual.
And on the ModyPoly website it clearly says:
Pitch bend Polysix and Mono/Poly only.
Thanks for the clarification......it was a misunderstanding on my part. I have a bad habit of not reading things thoroughly enough.

Many thanks again for all you do! :tu:

Post Reply

Return to “Tubbutec”