Filter Mod for ModyPoly for KLM354C Board

Support and discussion of Tubbutec products.

Moderators: Kent, tubbutec

Post Reply
User avatar
Altitude909
Super Deluxe Wiggler
Posts: 3544
Joined: Wed Aug 24, 2011 5:13 pm
Location: Meesheegan

Filter Mod for ModyPoly for KLM354C Board

Post by Altitude909 » Sun Oct 29, 2017 6:48 pm

The PCB in my Monopoly doesnt match what's in the install guide (at all). Its the KLM354C board.

Any clue where the orange wire needs to go?

User avatar
tubbutec
Veteran Wiggler
Posts: 661
Joined: Sat Dec 27, 2014 4:29 am
Location: Berlin
Contact:

Post by tubbutec » Sun Oct 29, 2017 11:56 pm

Some revisions have boards without the silk screen printing. Boards are identical though. Wire location is on the panel board, on the right side. Try to match it using the solder joints and traces.

User avatar
Altitude909
Super Deluxe Wiggler
Posts: 3544
Joined: Wed Aug 24, 2011 5:13 pm
Location: Meesheegan

Post by Altitude909 » Mon Oct 30, 2017 6:31 am

yep. That's what it was. I was looking at the wrong board which has a VR12 as well

Post Reply

Return to “Tubbutec”