MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

µTune Midi expansion + Intellijel 7u case
MUFF WIGGLER Forum Index -> Tubbutec  
Author µTune Midi expansion + Intellijel 7u case
tubbutec
Quote:
I have a µTune and recently also acquired an Intellijel 7u case. I
was wondering if it would be at all possible to connect the µTune to
the Midi ports that are built into the case via the expansion port. Do
you have any idea if this is possible?


This should be possible, but needs a bit of soldering. Can you provide closeup pictures of the Intellijel midi board in the case? Maybe even remove it to show the underside of the board?
hdh
I removed the board to get a few photos. I have to write 2 posts to upload the pictures, tho. So, I'll keep them to this thread. smile
hdh
hyper
hdh
Here are the photos. Apologies, the lighting is not that great.





Front view. MIDI plugs in this view are are (L to R): through, out, in.



Let me know if you need any more details. I'm not an expert at soldering, but I can get by.

Thank you!
tubbutec
I believe this is the correct way to solder. Id it does not work, switch connection 1 with 3 and 4 with 5.

A better way would be to use a connector for the pin header. We'd need to figure out the correct connections + Given your solder experience, just soldering 5 wires is probably the easier way.

MUFF WIGGLER Forum Index -> Tubbutec  
Page 1 of 1
Powered by phpBB © phpBB Group