MUFF WIGGLER Forum Index
 FAQ & Terms of UseFAQ & Terms Of Use   Wiggler RadioMW Radio   Muff Wiggler TwitterTwitter   Support the site @ PatreonPatreon 
 SearchSearch   RegisterSign up   Log inLog in 
WIGGLING 'LITE' IN GUEST MODE

Behringer umc1820/expert sleepers silent way/es-3
MUFF WIGGLER Forum Index -> Expert Sleepers  
Author Behringer umc1820/expert sleepers silent way/es-3
nhouse
Trying to figure out this on the new UMC1820. I assumed that the interface was dc coupled since i could run a very slow sub-audio lfo through the secondary output . The fact is that when i send a dc offset from silent way plugin trough the adat port to the ES-3 module , it works correctly.. if i send it through a normal secondary output of the interface straight to the target module, it immediately works and changes the value but then it comes back to the original state. Why?
Is because is actually not dc coupled?
cheers guys
os
That sounds like a classic symptom of non-DC-coupling.
MUFF WIGGLER Forum Index -> Expert Sleepers  
Page 1 of 1
Powered by phpBB © phpBB Group